Spacer Width: 50mm (2 inch) each side. 2 Spacers with Hubcentric Lip & 2 Spacers w/o Hubcentric Lip. Spacers w/o Lips will fit on axles that do not have clearance for the lips. Bolt Pattern: 8x170 to 8x170. Thread Pitch: 14mm x 2.
Suggested Torque Setting: 95-100 lbs. Spacer Type:2 Spacers with Hubcentric Lip & 2 Spacers w/o Hubcentric Lip. Spacers Will Not Work for DUALLY. Pre-assembled With Pressed Heat treated Grade 8 Studs (Equivalent to Metric Grade 10.9). This spacer set includes open end lug nuts to secure the spacers onto your factory hubs.Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to. 1 Shorten the factory studs.
2 The wheels need to have the open slots (cavities) between mounting holes. We recommend customers start threading the hardware on by hand so as to not cross thread or strip the threads. Once secured hand tight, use the torque wrench set to the proper torque as indicated from a lug nut torque chart below. Tighten the wheel bolts/lug nuts one after the other in a criss-cross pattern. Under- or over-tightening wheel-attaching hardware can be damaging and dangerous.When the lug nuts are over-torqued, this could cause stress fractures and increasing the risks of the lugs breaking under normal conditions. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Wheels, Tires & Parts\Other Wheel & Tire Parts".
The seller is "premierautoacc" and is located in this country: US. This item can be shipped to United States, Canada.